|
 |
 |
|
 |
Installation
Approx. 1 to 1 1/2 hours are required to set up the system
under normal studio conditions. Unfavorable conditions
such as uneven floors, inadequate access, very long track
moves, etc. will prolong the required setup time.
If 3D computer graphics data is to be transferred, all
mechanical parameters must be calibrated which may also
lead to an increase in setup time.
A great amount of time can be saved during shooting, if
a separate camera body is provided for the motion control,
which, in most cases, enables shooting to continue during
setup and programming. For this purpose, we offer our
ARRI 435 at extremely favorable rates if used on the rig.
|
 |
Programming times
The programming time varies with the complexity of the move. It starts with approximately 15 to 30 min for simple camera moves. But difficult moves with alternatives and changes may require over an hour.
If the camera has to remain in certain positions for set dressing, light adjustment, etc. this consequently leaves less time for programming.
After approval of the move by the director and client, focus is programmed. For a standard move approximately 15 min. can be expected. In this case, the camera assistant sets the focus at several positions, which are stored accordingly. The focus is part of the motion control move and is repeated in every take.
|
|
|
|
